Interface Configuration; Port Configuration; Configuring By Port List - Edge-Core ECS4610-24F Management Manual

5
P C
ORT ONFIGURATION
C
ONFIGURING BY
P L
ORT IST
I
NTERFACE
This chapter describes the following topics:

Port Configuration

– Configures connection settings, including auto-
◆
negotiation, or manual setting of speed, duplex mode, and flow control.
Port Mirroring – Sets the source and target ports for mirroring on the
◆
local switch.
Displaying Statistics
◆
statistics in table or chart form.
Trunk Configuration
◆
Traffic Segmentation
◆
segmented group of ports.
VLAN Trunking – Configures a tunnel across one or more intermediate
◆
switches which pass traffic for VLAN groups to which they do not
belong.
This section describes how to configure port connections, mirror traffic
from one port to another, and run cable diagnostics.
Use the Interface > Port > General (Configure by Port List) page to enable/
disable an interface, set auto-negotiation and the interface capabilities to
advertise, or manually fix the speed, duplex mode, and flow control.
CLI R
EFERENCES
"Interface Commands" on page 769
◆
C U
OMMAND SAGE
◆ Auto-negotiation must be disabled before you can configure or force a
Gigabit Ethernet interface to use the Speed/Duplex mode or Flow
Control options.
When using auto-negotiation, the optimal settings will be negotiated
◆
between the link partners based on their advertised capabilities. To set
the speed, duplex mode, or flow control under auto-negotiation, the
required operation modes must be specified in the capabilities list for
an interface.
– 125 –
C
ONFIGURATION
– Shows Interface, Etherlike, and RMON port
– Configures static or dynamic trunks.
– Configures the uplinks and down links to a