Console Port Settings - Edge-Core ECS4610-24F Management Manual

24-port layer 3 gigabit ethernet switch

Hide thumbs Also See for ECS4610-24F:

Table of Contents

Figure 14: Setting the Time Zone

Use the System > Console menu to configure connection parameters for

the switch's console port. You can access the onboard configuration

program by attaching a VT100 compatible device to the switch's serial

console port. Management access through the console port is controlled by

various parameters, including a password (only configurable through the

CLI), time outs, and basic communication settings. Note that these

parameters can be configured via the web or CLI interface.

"Line" on page 600

The following parameters are displayed in the web interface:

log into the CLI. If a login attempt is not detected within the timeout

interval, the connection is terminated for the session.

(Range: 0-300 seconds; Default: 0 seconds)

Exec Timeout – Sets the interval that the system waits until user input

is detected. If user input is not detected within the timeout interval, the

current session is terminated. (Range: 0-65535 seconds; Default: 600

Password Threshold – Sets the password intrusion threshold, which

limits the number of failed logon attempts. When the logon attempt

threshold is reached, the system interface becomes silent for a

specified amount of time (set by the Silent Time parameter) before

allowing the next logon attempt. (Range: 0-120; Default: 3 attempts)

Quiet Period – Sets the amount of time the management console is

inaccessible after the number of unsuccessful logon attempts has been

exceeded. (Range: 0-65535 seconds; Default: Disabled)

| Basic Management Tasks

Console Port Settings

Show Quick Links

Table of Contents