Assigning Interfaces To Multicast Services - Edge-Core ECS4610-24F Management Manual

A
SSIGNING
I
NTERFACES TO
M S
ULTICAST ERVICES
Use the Multicast > IGMP Snooping > IGMP Member (Add Static Member)
page to statically assign a multicast service to an interface.
Multicast filtering can be dynamically configured using IGMP Snooping and
IGMP Query messages (see
Parameters" on page 391). However, for certain applications that require
tighter control, it may be necessary to statically configure a multicast
service on the switch. First add all the ports attached to participating hosts
to a common VLAN, and then assign the multicast service to that VLAN
group.
CLI R
EFERENCES
"ip igmp snooping vlan static" on page 919
◆
C U
OMMAND SAGE
Static multicast addresses are never aged out.
◆
◆ When a multicast address is assigned to an interface in a specific VLAN,
the corresponding traffic can only be forwarded to ports within that
VLAN.
P
ARAMETERS
These parameters are displayed in the web interface:
VLAN – Specifies the VLAN which is to propagate the multicast service.
◆
(Range: 1-4093)
Interface – Activates the Port or Trunk scroll down list.
◆
◆ Port or Trunk – Specifies the interface assigned to a multicast group.
Multicast IP – The IP address for a specific multicast service.
◆
W I
EB NTERFACE
To statically assign an interface to a multicast service:
Click Multicast, IGMP Snooping, IGMP Member.
1.
Select Add Static Member from the Action list.
2.
Select the VLAN that will propagate the multicast service, specify the
3.
interface attached to a multicast service (through an IGMP-enabled
switch or multicast router), and enter the multicast IP address.
Click Apply.
4.
– 397 –
C
HAPTER
Layer 2 IGMP (Snooping and Query)
"Configuring IGMP Snooping and Query
| Multicast Filtering
15