Switchport Allowed Vlan - Edge-Core ECS4610-24F Management Manual

| VLAN Commands
C 36
HAPTER
Configuring VLAN Interfaces
switchport allowed
vlan
D S
EFAULT ETTING
All frame types
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
When set to receive all frame types, any received frames that are untagged
are assigned to the default VLAN.
E
XAMPLE
The following example shows how to restrict the traffic received on port 1
to tagged frames:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport acceptable-frame-types tagged
Console(config-if)#
R C
ELATED OMMANDS
switchport mode (842)
This command configures VLAN groups on the selected interface. Use the
no form to restore the default.
S
YNTAX
switchport allowed vlan {add vlan-list [tagged | untagged] |
remove vlan-list}
no switchport allowed vlan
add vlan-list - List of VLAN identifiers to add.
remove vlan-list - List of VLAN identifiers to remove.
vlan-list - Separate nonconsecutive VLAN identifiers with a comma
and no spaces; use a hyphen to designate a range of IDs. Do not
enter leading zeros. (Range: 1-4093).
D S
EFAULT ETTING
All ports are assigned to VLAN 1 by default.
The default frame type is untagged.
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
A port, or a trunk with switchport mode set to hybrid, must be
◆
assigned to at least one VLAN as untagged.
◆ If a trunk has switchport mode set to trunk (i.e., 1Q Trunk), then you
can only assign an interface to VLAN groups as a tagged member.
– 840 –