Ip Routing Commands; Global Routing Configuration; Table 139: Ip Routing Commands; Table 140: Global Routing Configuration Commands - Edge-Core ECS4610-24F Management Manual

45
G R C
LOBAL OUTING
IP R
OUTING
After network interfaces are configured for the switch, the paths used to
send traffic between different interfaces must be set. If routing is enabled
on the switch, traffic will automatically be forwarded between all of the
local subnetworks. However, to forward traffic to devices on other
subnetworks, either configure fixed paths with static routing commands, or
enable a dynamic routing protocol that exchanges information with other
routers on the network to automatically determine the best path to any
subnetwork.
This section includes commands for both static and dynamic routing. These
commands are used to connect between different local subnetworks or to
connect the router to the enterprise network.

Table 139: IP Routing Commands

Command Group Function
Global Routing Configures global parameters for static and dynamic routing,
Configuration displays the routing table and statistics for protocols used to
exchange routing information
Routing Information Configures global and interface specific parameters for RIP
Protocol (RIP)
Open Shortest Path First Configures global and interface specific parameters for OSPFv2
(OSPFv2)
ONFIGURATION
.

Table 140: Global Routing Configuration Commands

Command Function
ip route Configures static routes
maximum-paths Sets the maximum number of paths allowed
show ip route Displays specified entries in the routing table
show ip route database Displays static or dynamically learned entries in the
routing table
show ip traffic Displays statistics for IP, ICMP, UDP, TCP and ARP
protocols
– 1019 –
C
OMMANDS
Mode
GC
GC
PE
PE
PE