Show Ip Pim Interface; Show Ip Pim Neighbor - Edge-Core ECS4610-24F Management Manual

| Multicast Routing Commands
C 46
HAPTER
PIM Multicast Routing
show ip pim
interface
show ip pim
neighbor
Also, if a Hello message is received from a new neighbor, the receiving
◆
router will send its own Hello message after a random delay between 0
and the trigger-hello-delay.
E
XAMPLE
Console(config-if)#ip pim trigger-hello-delay 3
Console(config-if)#
This command displays information about interfaces configured for PIM.
S
YNTAX
show ip pim [interface vlan vlan-id]
vlan-id - VLAN ID (Range: 1-4094)
C M
OMMAND ODE
Normal Exec, Privileged Exec
C U
OMMAND SAGE
This command displays the PIM settings for the specified interface as
described in the preceding pages. It also shows the address of the
designated PIM router and the number of neighboring PIM routers.
E
XAMPLE
Console#show ip pim interface vlan 1
PIM is enabled.
Vlan 1 is up.
PIM Mode
IP Address
Hello Interval
Hello HoldTime
Triggered Hello Delay
Join/Prune Holdtime
Lan Prune Delay
Propagation Delay
Override Interval
Graft Retry Interval
Max Graft Retries
State Refresh Ori Int
Console#
This command displays information about PIM neighbors.
S
YNTAX
show ip pim neighbor [interface vlan vlan-id]
vlan-id - VLAN ID (Range: 1-4094)
– 1098 –
: Dense Mode
: 192.168.0.2
: 30 sec
: 105 sec
: 5 sec
: 210 sec
: Disabled
: 500 ms
: 2500 ms
: 3 sec
: 3
: 60 sec