Ip Ospf Transmit-Delay - Edge-Core ECS4610-24F Management Manual

| IP Routing Commands
C 45
HAPTER
Open Shortest Path First (OSPFv2)
ip ospf transmit-
delay
C U
OMMAND SAGE
A router will resend an LSA to a neighbor if it receives no
◆
acknowledgment after the specified retransmit interval. The retransmit
interval should be set to a conservative value that provides an
adequate flow of routing information, but does not produce
unnecessary protocol traffic. Note that this value should be larger for
virtual links.
Set this interval to a value that is greater than the round-trip delay
◆
between any two routers on the attached network to avoid unnecessary
retransmissions.
E
XAMPLE
Console(config)#interface vlan 1
Console(config-if)#ip ospf retransmit-interval 7
Console(config-if)#
This command sets the estimated time to send a link-state update packet
over an interface. Use the no form to restore the default value.
S
YNTAX
ip ospf [ip-address] transmit-delay seconds
no ip ospf [ip-address] transmit-delay
ip-address - This parameter can be used to indicate a specific IP
address connected to the current interface. If not specified, the
command applies to all networks connected to the current interface.
seconds - Sets the estimated time required to send a link-state
update. (Range: 1-65535)
C M
OMMAND ODE
Interface Configuration (VLAN)
D S
EFAULT ETTING
1 second
C U
OMMAND SAGE
LSAs have their age incremented by this delay before transmission.
◆
When estimating the transmit delay, consider both the transmission
and propagation delays for an interface. Set the transmit delay
according to link speed, using larger values for lower-speed links.
If this delay is not added, the time required to transmit an LSA over the
◆
link is not taken into consideration by the routing process. On slow
links, the router may send packets more quickly than devices can
receive them. To avoid this problem, use the transmit delay to force the
router to wait a specified interval between transmissions.
– 1068 –