Ip Arp Inspection Filter - Edge-Core ECS4610-24F Management Manual

| General Security Measures
C 28
HAPTER
ARP Inspection
ip arp inspection
filter
This command specifies an ARP ACL to apply to one or more VLANs. Use
the no form to remove an ACL binding.
S
YNTAX
ip arp inspection filter arp-acl-name vlan {vlan-id | vlan-range}
[static]
arp-acl-name - Name of an ARP ACL.
(Maximum length: 16 characters)
vlan-id - VLAN ID. (Range: 1-4093)
vlan-range - A consecutive range of VLANs indicated by the use a
hyphen, or a random group of VLANs with each entry separated by
a comma.
static - ARP packets are only validated against the specified ACL,
address bindings in the DHCP snooping database is not checked.
D S
EFAULT ETTING
ARP ACLs are not bound to any VLAN
Static mode is not enabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
ARP ACLs are configured with the commands described on
◆
If static mode is enabled, the switch compares ARP packets to the
◆
specified ARP ACLs. Packets matching an IP-to-MAC address binding in
a permit or deny rule are processed accordingly. Packets not matching
any of the ACL rules are dropped. Address bindings in the DHCP
snooping database are not checked.
If static mode is not enabled, packets are first validated against the
◆
specified ARP ACL. Packets matching a deny rule are dropped. All
remaining packets are validated against the address bindings in the
DHCP snooping database.
E
XAMPLE
Console(config)#ip arp inspection filter sales vlan 1
Console(config)#
– 740 –
page 298.