Show Startup-Config - Edge-Core ECS4620-28P Cli Reference Manual

show startup-config

username guest access-level 0
username guest password 7 084e0343a0486ff05530df6c705c8bb4
enable password 7 1b3231655cebb7a1f783eddf27d254ca
!
vlan database
VLAN 1 name DefaultVlan media ethernet state active
!
spanning-tree mst configuration
!
interface ethernet 1/1
...
interface ethernet 1/52
no negotiation
!
interface vlan 1
ip address dhcp
!
interface vlan 1
!
line console
!
line vty
!
end
!
Console#
Related Commands
show startup-config (133)
This command displays the configuration file stored in non-volatile memory that is
used to start up the system.
Command Mode
Privileged Exec
Command Usage
◆
Use this command in conjunction with the show running-config command to
compare the information in running memory to the information stored in non-
volatile memory.
◆
This command displays settings for key command modes. Each mode group is
separated by "!" symbols, and includes the configuration mode command, and
corresponding commands. This command displays the following information:
MAC address for each switch in the stack
■
SNMP community strings
■
■ SNMP trap authentication
Users (names and access levels)
■
VLAN database (VLAN ID, name and state)
■
Multiple spanning tree instances (name and interfaces)
■
Interface settings and VLAN configuration settings for each interface
■
IP address for VLANs
■
Any configured settings for the console port and Telnet
■
Chapter 4
– 133 –
| System Management Commands
System Status