Clear Ip Ospf Process; Area Default-Cost - Edge-Core ECS4610-24F Management Manual

| IP Routing Commands
C 45
HAPTER
Open Shortest Path First (OSPFv2)
clear ip ospf
process

area default-cost

This command clears and restarts the OSPF routing process. Specify the
process ID to clear a particular OSPF process. When no process ID is
specified, this command clears all running OSPF processes.
S
YNTAX
clear ip ospf [process-id] process
process-id - Specifies the routing process ID. (Range: 1-65535)
D S
EFAULT ETTING
Clears all routing processes.
C M
OMMAND ODE
Privileged Exec
E
XAMPLE
Console#clear ip ospf process
Console#
This command specifies a cost for the default summary route sent into a
stub or NSSA from an Area Border Router (ABR). Use the no form to
remove the assigned default cost.
S
YNTAX
area area-id default-cost cost
no area area-id default-cost
area-id - Identifies the stub or NSSA. (The area ID can be in the
form of an IPv4 address or as a four octet unsigned integer ranging
from 0-4294967295.)
cost - Cost for the default summary route sent to a stub or NSSA.
(Range: 0-16777215)
C M
OMMAND ODE
Router Configuration
D S
EFAULT ETTING
Default cost: 1
C U
OMMAND SAGE
If the default cost is set to "0," the router will not advertise a default
◆
route into the attached stub or NSSA.
E
XAMPLE
Console(config-router)#area 10.3.9.0 default-cost 10
Console(config-router)#
– 1048 –