Timers Spf - Edge-Core ECS4610-24F Management Manual

24-port layer 3 gigabit ethernet switch

Hide thumbs Also See for ECS4610-24F:

Table of Contents

If this router already has registered neighbors, the new router ID will

be used when the router is rebooted, or manually restarted by entering

the no router ospf followed by the router ospf command.

If the priority values of the routers bidding to be the designated router

or backup designated router for an area are equal, the router with the

highest ID is elected.

Console(config-router)#router-id 10.1.1.1

Console(config-router)#

router ospf (1043)

This command configures the delay after receiving a topology change and

timers spf

starting the shortest path first (SPF) calculation, and the hold time

between making two consecutive SPF calculations. Use the no form to

restore the default values.

timers spf spf-delay spf-holdtime

no timers spf

spf-delay - The delay after receiving a topology change notification

and starting the SPF calculation. (Range: 0-2147483647 seconds)

spf-holdtime - Minimum time between two consecutive SPF

calculations. (Range: 0-2147483647 seconds)

Router Configuration

SPF delay: 5 seconds

SPF holdtime: 10 seconds

Setting the SPF holdtime to 0 means that there is no delay between

consecutive calculations.

Using a low value allows the router to switch to a new path faster, but

uses more CPU processing time.

Console(config-router)#timers spf 20

Console(config-router)#

| IP Routing Commands

Open Shortest Path First (OSPFv2)

Show Quick Links

Table of Contents