Enable - Edge-Core ECS4610-24F Management Manual

24-port layer 3 gigabit ethernet switch

Hide thumbs Also See for ECS4610-24F:

Table of Contents

This command resets the entire system.

Any combination of reload options may be specified. If the same option

is re-specified, the previous setting will be overwritten.

When the system is restarted, it will always run the Power-On Self-Test.

It will also retain all configuration information stored in non-volatile

memory by the

"copy" on page

This example shows how to reset the switch after 30 minutes:

Console(config)#reload in minute 30

*** --- Rebooting at January

Are you sure to reboot the system at the specified time? <y/n>

This command activates Privileged Exec mode. In privileged mode,

enable

additional commands are available, and certain commands display

additional information. See

enable [level]

level - Privilege level to log into the device.

The device has two predefined privilege levels: 0: Normal Exec,

15: Privileged Exec. Enter level 15 to access Privileged Exec mode.

"super" is the default password required to change the command mode

from Normal Exec to Privileged Exec. (To set this password, see the

enable password

The "#" character is appended to the end of the prompt to indicate that

the system is in privileged access mode.

copy running-config startup-config

1 02:10:43 2007 ---

"Understanding Command Modes" on

| General Commands

command (See

Show Quick Links

Table of Contents