Traffic Segmentation; Enabling Traffic Segmentation - Edge-Core ECS4610-24F Management Manual

T S
RAFFIC EGMENTATION
E T
NABLING RAFFIC
S
EGMENTATION
If tighter security is required for passing traffic from different clients
through downlink ports on the local network and over uplink ports to the
service provider, port-based traffic segmentation can be used to isolate
traffic between clients on different downlink ports. Data traffic on downlink
ports is only forwarded to, and from, uplink ports.
Use the Interface > Traffic Segmentation (Configure Global) page to enable

traffic segmentation.

CLI R
EFERENCES
"Configuring Port-based Traffic Segmentation" on page 850
◆
P
ARAMETERS
These parameters are displayed in the web interface:
Status – Enables port-based traffic segmentation. (Default: Disabled)
◆
W I
EB NTERFACE
To enable traffic segmentation:
Click Interface, Traffic Segmentation.
1.
Select Configure Global from the Step list.
2.
Mark the Enabled check box.
3.
Click Apply.
4.
Figure 46: Enabling Traffic Segmentation
– 149 –
| Interface Configuration
C 5
HAPTER
Traffic Segmentation