Domain-Name; Hardware-Address - Edge-Core ECS4610-24F Management Manual

◆
E
This command specifies the domain name for a DHCP client. Use the no

domain-name

form to remove the domain name.
S
D
None
C
DHCP Pool Configuration
E
This command specifies the hardware address of a DHCP client. This

hardware-address

command is valid for manual bindings only. Use the no form to remove the
hardware address.
S
D
If no type is specified, the default protocol is Ethernet.
Servers are listed in order of preference (starting with address1 as the
most preferred server).
XAMPLE
Console(config-dhcp)#dns-server 10.1.1.253 192.168.3.19
Console(config-dhcp)#
YNTAX
domain-name domain
no domain-name
domain - Specifies the domain name of the client.
(Range: 1-32 characters)
S
EFAULT ETTING
M
OMMAND ODE
XAMPLE
Console(config-dhcp)#domain-name sample.com
Console(config-dhcp)#
YNTAX
hardware-address hardware-address type
no hardware-address
hardware-address - Specifies the MAC address of the client device.
type - Indicates the following protocol used on the client device:
• ethernet
• ieee802
• fddi
S
EFAULT ETTING
– 987 –
| DHCP Commands
C 42
HAPTER
DHCP Server