Timeout Login Response; Disconnect - Edge-Core ECS4610-24F Management Manual

| System Management Commands
C 24
HAPTER
Line
timeout login
response

disconnect

This command sets the interval that the system waits for a user to log into
the CLI. Use the no form to restore the default setting.
S
YNTAX
timeout login response [seconds]
no timeout login response
seconds - Integer that specifies the timeout interval.
(Range: 0 - 300 seconds; 0: disabled)
D S
EFAULT ETTING
CLI: Disabled (0 seconds)
Telnet: 300 seconds
C M
OMMAND ODE
Line Configuration
C U
OMMAND SAGE
If a login attempt is not detected within the timeout interval, the
◆
connection is terminated for the session.
This command applies to both the local console and Telnet connections.
◆
◆ The timeout for Telnet cannot be disabled.
Using the command without specifying a timeout restores the default
◆
setting.
E
XAMPLE
To set the timeout to two minutes, enter this command:
Console(config-line)#timeout login response 120
Console(config-line)#
This command terminates an SSH, Telnet, or console connection.
S
YNTAX
disconnect session-id
session-id – The session identifier for an SSH, Telnet or console
connection. (Range: 0-4)
C M
OMMAND ODE
Privileged Exec
C U
OMMAND SAGE
Specifying session identifier "0" will disconnect the console connection.
Specifying any other identifiers for an active session will disconnect an SSH
or Telnet connection.
– 608 –