Configuring Mvr Interface Status - Edge-Core ECS4610-24F Management Manual

| Multicast Filtering
C 15
HAPTER
Multicast VLAN Registration
C MVR
ONFIGURING
I S
NTERFACE TATUS
W I
EB NTERFACE
To configure multicast groups for the MVR VLAN:
Click Multicast, MVR.
1.
Select Configure Group Range from the Step list.
2.
Select Add from the Action list.
3.
Add the multicast groups that will stream traffic to participating hosts.
4.
Click Apply.
5.
Figure 252: Configuring the Group Range for MVR
To show the multicast groups assigned to the MVR VLAN:
Click Multicast, MVR.
1.
Select Configure Group Range from the Step list.
2.
Select Show from the Action list.
3.
Figure 253: Showing the Configured Group Range for MVR
Use the Multicast > MVR (Configure Interface) page to configure each
interface that participates in the MVR protocol as a source port or receiver
port. If you are sure that only one subscriber attached to an interface is
receiving multicast services, you can enable the immediate leave function.
CLI R
EFERENCES
"Multicast VLAN Registration" on page 930
◆
– 424 –