Attaching A Policy Map To A Port - Edge-Core ECS4610-24F Management Manual

A P
TTACHING A OLICY
M P
AP TO A ORT
Use the Traffic > DiffServ (Configure Interface) page to bind a policy map
to an ingress port.
CLI R
EFERENCES
"Quality of Service Commands" on page 885
◆
C U
OMMAND SAGE
First define a class map, define a policy map, and bind the service
◆
policy to the required interface.
Only one policy map can be bound to an interface.
◆
◆ The switch does not allow a policy map to be bound to an interface for
egress traffic.
P
ARAMETERS
These parameters are displayed in the web interface:
Port – Specifies a port.
◆
Ingress – Applies the selected rule to ingress traffic.
◆
W I
EB NTERFACE
To bind a policy map to a port:
Click Traffic, DiffServ.
1.
Select Configure Interface from the Step list.
2.
Check the box under the Ingress field to enable a policy map for a port.
3.
Select a policy map from the scroll-down box.
4.
Click Apply.
5.
Figure 113: Attaching a Policy Map to a Port
– 237 –
| Quality of Service
C 11
HAPTER

Attaching a Policy Map to a Port