Multicast Routing Commands; General Multicast Routing; Ip Multicast-Routing; Table 154: Multicast Routing Commands - Edge-Core ECS4610-24F Management Manual

46
G M
ENERAL ULTICAST

ip multicast-routing

M
ULTICAST
Multicast routers can use various kinds of multicast routing protocols to
deliver IP multicast packets across different subnetworks. This router
supports Protocol Independent Multicasting (PIM). (Note that IGMP will be
enabled for any interface that is using multicast routing.)

Table 154: Multicast Routing Commands

Command Group Function

General Multicast Routing

Enables IP multicast routing globally; also displays the IP
multicast routing table created from static and dynamic routing
information
Static Multicast Routing Configures static multicast router ports
PIM Multicast Routing Configures global and interface settings for PIM-DM and PIM-SM
R
OUTING
This section describes commands used to configure multicast routing
globally on the switch.

Table 155: General Multicast Routing Commands

Command Function
ip multicast-routing Enables IP multicast routing
show ip mroute Shows the IP multicast routing table
This command enables IPv4 multicast routing. Use the no form to disable
IP multicast routing.
S
YNTAX
[no] ip multicast-routing
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
This command is used to enable IP multicast routing globally for the
◆
router. A specific multicast routing protocol also needs to be enabled on
– 1085 –
R C
OUTING OMMANDS
Mode
GC
PE