Dot1X Default; Dot1X Eapol-Pass-Through - Edge-Core ECS4610-24F Management Manual

| Authentication Commands
C 27
HAPTER
802.1X Port Authentication

dot1x default

dot1x eapol-pass-
through
Table 64: 802.1X Port Authentication Commands (Continued)
Command
dot1x timeout quiet-period
dot1x timeout re-
authperiod
dot1x timeout supp-timeout
dot1x timeout tx-period
dot1x re-authenticate
Display Information Commands
show dot1x
This command sets all configurable dot1x global and port settings to their
default values.
C M
OMMAND ODE
Global Configuration
E
XAMPLE
Console(config)#dot1x default
Console(config)#
This command passes EAPOL frames through to all ports in STP forwarding
state when dot1x is globally disabled. Use the no form to restore the
default.
S
YNTAX
[no] dot1x eapol-pass-through
D S
EFAULT ETTING
Discards all EAPOL frames when dot1x is globally disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
When this device is functioning as intermediate node in the network
◆
and does not need to perform dot1x authentication, the dot1x eapol
pass-through command can be used to forward EAPOL frames from
other switches on to the authentication servers, thereby allowing the
authentication process to still be carried out by switches located on the
edge of the network.
– 694 –
Function
Sets the time that a switch port waits after the Max
Request Count has been exceeded before attempting
to acquire a new client
Sets the time period after which a connected client
must be re-authenticated
Sets the interval for a supplicant to respond
Sets the time period during an authentication session
that the switch waits before re-transmitting an EAP
packet
Forces re-authentication on specific ports
Shows all dot1x related information
Mode
IC
IC
IC
IC
PE
PE