Router Ospf - Edge-Core ECS4610-24F Management Manual

Table 142: Open Shortest Path First Commands (Continued)
Command
ip ospf retransmit-
interval
ip ospf transmit-delay
passive-interface
Display Information
show ip ospf
show ip ospf
border-routers
show ip ospf database
show ip ospf interface
show ip ospf neighbor
show ip ospf route
show ip ospf virtual-links
show ip protocols ospf
This command enables Open Shortest Path First (OSPFv2) routing for all IP

router ospf

interfaces on the router and enters router configuration mode. Use the no
form to disable OSPF for all processes or for a specified process.
S
YNTAX
[no] router ospf [process-id]
process-id - Process ID must be entered when configuring multiple
routing instances. (Range: 1-65535; Default: 1)
C
OMMAND
Global Configuration
D
EFAULT
No routing process is defined.
C
OMMAND
OSPF is used to specify how routers exchange routing table
◆
information.
◆ This command is also used to enter router configuration mode.
If the process ID is not defined, the default is instance 1.
◆
Function
Specifies the time between resending a link-state
advertisement
Estimates time to send a link-state update packet over
an interface
Suppresses OSPF routing traffic on the specified
interface
Displays general information about the routing
processes
Displays routing table entries for Area Border Routers
(ABR) and Autonomous System Boundary Routers
(ASBR)
Shows information about different LSAs in the
database
Displays interface information
Displays neighbor information
Displays the OSPF routing table
Displays parameters and the adjacency state of virtual
links
Displays OSPF process parameters
M
ODE
S
ETTING
U
SAGE
– 1043 –
| IP Routing Commands
C 45
HAPTER
Open Shortest Path First (OSPFv2)
Mode
IC
IC
RC
PE
PE
PE
PE
PE
PE
PE
PE