Displaying The Bsr Router - Edge-Core ECS4610-24F Management Manual

D BSR
ISPLAYING THE
R
OUTER
Figure 372: Configuring an RP Candidate
To display settings for an RP candidate:
Click Multicast, Multicast Routing, PIM-SM.
1.
Select RP Candidate from the Step list.
2.
Select Show from the Action list.
3.
Select an interface from the VLAN list.
4.
Figure 373: Showing Settings for an RP Candidate
Use the Routing Protocol > PIM > SM (Show Information – Show BSR
Router) page to display Information about the bootstrap router (BSR).
CLI R
EFERENCES
"show ip pim bsr-router" on page 1110
◆
P
ARAMETERS
These parameters are displayed in the web interface:
◆ IP Address – IP address of interface configured as the BSR.
Uptime – The time this BSR has been up and running.
◆
– 561 –
| Multicast Routing
C 21
HAPTER
Configuring PIM for IPv4