Polycom RealPresence 4000 Administrator's Manual page 675

•
•
•
•
Polycom, Inc.
Table 21-12 System Information (Continued)
Field
Card Configuration Mode
The RMX only switches between MPM, MPM+ and MPMx Card Configuration Modes if MPM /
MPM+ / MPMx cards are removed or swapped while it is running.
The Card Configuration Mode switch occurs during the next restart.
Installing or swapping MPM / MPM+ / MPMx cards while the system is off will not cause a mode
switch when the system is restarted – it will restart in the Card Configuration Mode that was
active previous to powering down.
From Version 7.1, MPM media cards are not supported.
Description
Indicates the MCU configuration as derived from the installed
media cards:
•
MPM: Only MPM cards are supported. MPM+ and MPMx
cards in the system are disabled. It is the mode used in
previous RMX versions.
From Version 7.1, MPM media cards are not supported.
•
MPM+: Only MPM+ cards are supported. MPM and MPMx
cards in the system are disabled.
•
MPMx: Only MPMx cards are supported. MPM and MPM+
cards in the system are disabled.
Note: When started with Version 7.0 installed, the RMX enters
MPM+ mode by default, even if no media cards are installed:
•
The RMX only switches between MPM, MPM+ and MPMx
Card Configuration Modes if MPM, MPM+ or MPMx cards are
removed or swapped while it is powered on.
•
The Card Configuration Mode switch occurs during the next
restart.
•
Installing or swapping MPM, MPM+ or MPMx cards while the
system is off will not cause a mode switch when the system is
restarted - it will restart in the Card Configuration Mode that
was active previous to powering down.
Chapter 21-RMX Administration and Utilities
21-29