Manually Adding Flags To The Cs_Module_Parameters Tab - Polycom RealPresence 4000 Administrator's Manual

4
5
For flag changes (including deletion) to take effect, reset the MCU. For more information see
"Resetting the Collaboration Server (RMX)" on page 20-86.

Manually Adding Flags to the CS_MODULE_PARAMETERS Tab

Using the procedure to manually add flags to the System Configuration, the following flags
can be manually added to the CS_MODULE_PARAMETERS tab:
Table 22-3
Flag
CS_ENABLE_EPC
H245_TUNNELING
Polycom, Inc.
Table 22-2 Manually Added System Flags – MCMS_PARAMETERS (Continued)
Flag
VSW_HD720p50-
60_HP_THRESHOLD_BITR
ATE
VSW_RATE_TOLERANCE_
PERECENT
VSW_SD_HP_THRESHOLD
_BITRATE
WRONG_NUMBER_DIAL_
RETRIES
Click OK to close the New Flag dialog box.
The new flag is added to the flags list.
Click OK to close the System Flags dialog box.
Manually Added Flags - CS_MODULE_PARAMETERS Tab
Description
Add this flag with the value YES (default value is NO) to enable endpoints
that support People+Content and require a different signaling (for example,
FX endpoints) to receive Content.
For use in the Avaya Environment.
In the Avaya Environment, set the flag to YES to ensure that H.245 is
tunneled through H.225. Both H.245 and H.225 will use the same signaling
port.
Default: NO.
Description
Controls the Minimum Threshold Line Rate (kbps) for
HD720p50 and HD720p50 resolutions for High Profile-
enabled VSW conferences.
Default: 832
Determines the percentage of bandwidth that can be
deducted from the required bandwidth to allow participants to
connect to the conference.
For example, a value of 20 will allow a participant to connect
to the conference if the allocated line rate is up to 20% lower
than the conference line rate (or between 80% to 100% of the
required bandwidth).
Range: 0 - 75
Default: 0
Controls the Minimum Threshold Line Rate (kbps) for SD
resolution for High Profile-enabled VSW conferences.
Default: 128
The number of re-dial attempts for a wrong destination
number or a wrong destination number time-out.
Range: 0 - 5
Default: 3
A flag value of 0 means that no redials are attempted.
Chapter 22-System Configuration Flags
22-43