Configuring The Rmx - Polycom RealPresence 4000 Administrator's Manual

Table I-5
The following Polycom peripheral:
•
SIP ONLY (no TIP support)
Spectralink wireless phones 8020/8030
Polycom VVX 1500
Polycom VVX 1500 C
KIRK Wireless Server 300/600v3/6000
The following procedures 1 - 16 are a summary of the configuration procedures.
The detailed procedures 1 - 16 begin with "Procedure 1: Set the
MIN_TIP_COMPATIBILITY_LINE_RATE System Flag" on page I-19.

Configuring the RMX

1
2
3
4
5
6
7
Configuring DMA
If DMA is present in the configuration perform procedures 8 and 9, otherwise skip to
procedure 10.
8
9
Configuring CMA
10 Configuring CMA to route H.323 calls to RMX
11 Configuring CMA for use with Cisco IOS Gatekeeper (Neighbored)
12 Configuring CMA to route H.323 calls to CUCM
13 Configuring CMA to route non-H.323 calls to CUCM
Configuring Endpoints
14 Configuring H.323 endpoints to register to the CMA or IOS gatekeeper
Polycom, Inc.
Supported current Polycom products
Polycom Touch Control
Set the MIN_TIP_COMPATIBILITY_LINE_RATE System Flag
Configuring the RMX to statically route outbound SIP calls to DMA or CUCM
Configuring the RMX's H.323 Network Service to register with CMA gatekeeper
Configuring a TIP enabled Profile on the RMX
Configuring an Ad Hoc Entry Queue on the RMX if DMA is not used
Configuring a Meeting Room on the RMX
Configuring Participant Properties for dial out calls
Configuring DMA to route SIP calls to CUCM
Configuring a Virtual Meeting Room (VMR)
The procedures for configuring DMA are described in detail in the Polycom Unified
Communications Deployment Guide for Cisco Environments.
The procedures for configuring CMA are described in detail in the Polycom Unified
Communications Deployment Guide for Cisco Environments.
The procedures for configuring H.323 endpoints are described in detail in the Polycom
Unified Communications Deployment Guide for Cisco Environments.
Appendix I-Polycom Open Collaboration Network (POCN)
1.3.0
Version(s)
V4.0
V3.3.1
I-17