Resolving Monitor Display Problems - RADVision Scopia XT5000 Administrator's Manual

6. From the web interface only, select Save.

Resolving Monitor Display Problems

Problem
Solution
Problem
Solution
Solution
Solution
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
Figure 83: Testing the audio from the web interface
b. Bring the Microphone Pod at about 1 m (3 feet) from the monitor. Keep silent.
c. Navigate to Audio delay detection
The monitor generates an evaluation noise and the Codec Unit estimates the audio
delay introduced by the monitor. The display shows the audio delay in milliseconds.
The XT Codec Unit uses this manually adjusted delay to calculate the audio delay and
improve the echo canceller performance.
The system displays a flickering or blank screen.
The rear panel of the XT Codec Unit features 2 HD outputs for connecting a main and
auxiliary screen. For cabling, see the cabling diagram in the Quick Setup Guide.
Your system administrator must configure the system for correct video resolution.
When you are not in a call, you can set the refresh frequency of the monitor display:
• Set to 50 Hz by pressing
• Set to 60 Hz by pressing
The system displays a blank screen.
Verify the power cord of the XT Codec Unit is connected properly at both ends.
Verify the monitor's power cord is connected properly at both ends.
Check that the monitor power switch is set to ON.
and select Yes.
then 5.
then 6.
Troubleshooting the Scopia XT Endpoint for IP Office | 136