Chapter 3: Getting Started With Managing The Xt Endpoint; Initial Workflow For Administrators - RADVision Scopia XT5000 Administrator's Manual

Chapter 3 | Getting Started with Managing
To get started with configuring the XT Endpoint and customizing it to fit your network requirements, we recommend
following the workflow described in
You can manage the XT Endpoint as follows:
• From the endpoint
You can perform all maintenance from the endpoint itself using the XT Remote Control Unit. To do so, you must
first enable advanced configuration (see
• From the web interface
You can perform all maintenance from the web interface. To do so, remote management must be enabled, as
described in Managing your XT Endpoint from the Web Interface
For information on configuring settings, such as the language and network settings, see
38.
Navigation
•

Initial Workflow for Administrators

•
Managing your XT Endpoint from the Web Interface
•
Managing your XT Endpoint Locally from the Endpoint
Initial Workflow for Administrators
About this task
To configure the Scopia XT Endpoint for IP Office and customize it for your network requirements, follow
the recommended workflow described below. For example, you can secure videoconferences by
enabling encryption.
Before you begin
Activate the Scopia XT Endpoint for IP Office and perform the required basic settings, as described in
the Quick Setup Guide for Scopia XT Endpoint for IP Office.
Procedure
1. Decide how to incorporate the XT Endpoint into your deployment, as described in
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
the XT Endpoint
Initial Workflow for Administrators
Maintaining the XT Endpoint Locally from the Endpoint
on page 22
the Topology of the Scopia XT Endpoint for IP Office Deployment
on page 22.
on page 24.
on page 24
on page 29
Getting Started with Managing the XT Endpoint | 22
on page 35).
Initial Configuration on page
Planning
on page 11.