Adjusting The Image Position - RADVision Scopia XT5000 Administrator's Manual

Adjusting the Image Position

About this task
If your monitor does not center the image correctly, perform this procedure. This can be done from the
endpoint itself only.
Before you begin
This procedure is performed as part of the Quick Setup Wizard, after
Language
Access the quick setup wizard from the endpoint, as described in
on page 45.
Procedure
1. Examine the image on the monitor to decide if you need to adjust the image position.
2. Press 1 to align the top left corner.
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
If performing the quick setup from the web interface, access the quick setup from the
endpoint to adjust the image. This can be done at any time.
on page 46.
The triangles in the top left corner and bottom right corner must be fully visible so that the
white border of the triangle is fully visible on all sides.
If the image is centered correctly, skip this procedure and select Next.
Figure 20: Examining the image position
Setting the System Name and
Accessing the Quick Setup Procedure
Initial Configuration | 48