RADVision Scopia XT5000 Administrator's Manual page 143

Solution
Solution
Solution
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
Change the video source to the correct camera, as described below.
1. Select Control Camera from the Main menu (or from the In-Call menu, during a call)
and press ok/menu.
2. Press ok/menu again.
3. Select Video Source.
Ensure the camera is correctly connected to the system. For details, see the Installation
Guide for the Scopia XT Endpoint for IP Office.
Make sure the Moving setting is enabled.
If configuring from the endpoint, you must first enable advanced configuration, as described
in Maintaining the XT Endpoint Locally from the Endpoint
1. Access the general camera settings by doing one of the following:
• From the endpoint's main menu, select Configure > Advanced > I/O connections
> Cameras > HD1 from the Main menu.
• From the XT Endpoint web interface, select Administrator Settings > I/O
connections > Cameras > HD1.
Figure 88: Selecting a video source
Troubleshooting the Scopia XT Endpoint for IP Office | 143
on page 35.