RADVision Scopia XT5000 Administrator's Manual page 85

3. Set the field as described in
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
Figure 42: Configuring the GLAN parameters from the web interface
To avoid connectivity issues, match these settings to the equivalent settings in the network.
Table 26: Configuring network connectivity
Field Name
MTU Sets the maximum size of each IP packet the XT Codec Unit can
send to the network.
If the system or the remote endpoint transmits IP packets larger
than the configured MTU size, they are dropped or fragmented. To
avoid packet loss or fragmentation, decrease MTU. If packets are
smaller than the configured MTU size, increase MTU.
The maximum and minimum values you enter in this field depend
on the mode selected for placing calls: IPv4 or IPv6. (These are
configured in
and IPv6 MTU size is set by default to 1360 octets. You can set the
MTU size to these ranges:
Speed/Duplex mode Set the speed and transition mode as follows:
Table 26: Configuring network connectivity
Setting
Configuring IP Addresses
• The minimum allowed value for IPv4 is 576 octets.
• The minimum allowed value or IPv6 is 1280 octets.
• The maximum allowed value for both is 1500 octets.
• Automatic: The XT Codec Unit selects the Ethernet speed
and transmission mode. We recommend this default mode.
• Auto - up to 100/Full, Auto - up to 100/Half, Auto - up to
10/Full, Auto - up to 10/Half: If necessary for your network
requirements, select one of these semi-automatic modes. The
XT Codec Unit selects the Ethernet speed and transmission
mode according to the specified values.
• Manual: You must configure speed and transmission mode
and know the network and remote endpoints requirements.
on page 85.
on page 81. Both for IPv4
Initial Configuration | 85