Configuring Network Settings; Configuring Glan Use; Configuring Ip Addresses - RADVision Scopia XT5000 Administrator's Manual

3. From the web interface only, select Save.

Configuring Network Settings

Part of the initial configuration is ensuring the network is properly set up. The settings are detailed in
these sections:
Navigation
•

Configuring GLAN Use

•
Registering the Scopia XT Endpoint for IP Office with a Gatekeeper
•
Configuring Call Settings
•
Configuring Scopia XT Endpoint for IP Office to use an LDAP Directory
Configuring GLAN Use
You can configure GLAN use for Scopia XT Endpoint for IP Office.
Before you begin to configure GLAN use, you must prepare your network for videoconferencing. Consult
your network administrator for more information.
These sections describe step-by-step procedures to configure settings for GLAN use:
Navigation
•

Configuring IP Addresses

•
Configuring Network Connectivity
•
Enabling NAT and Firewall Traversal with Scopia XT Endpoint for IP Office
•
Determining the Priority of Audio versus Video Quality
Configuring IP Addresses
About this task
To place calls, the system supports either IPv4-only mode, or dual IPv4 and IPv6 mode.
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
Field Name
Rx remote to output
Analog to output
on page 81
on page 92
on page 81
If enabled, sends the remote audio of other
conference participants to one or more of the
system's audio output channels: HD1, digital
audio or analog output.
If enabled, it routes the analog input port to one or
more of the system's audio output channels: HD1,
digital audio or analog output.
on page 84
on page 88
Description
on page 89
on page 96
on page 86
Initial Configuration | 81