Resolving Monitor Display Problems
Problem
Solution
Problem
Solution
Solution
Solution
Solution
RADVISION | User Guide for Scopia XT4000 Series Version 3.1.1
Figure 5-2
The system displays a flickering or blank screen.
The rear panel of the XT Codec Unit features 2 HD outputs for connecting a main and
auxiliary screen. For cabling, see the cabling diagram in the Quick Setup Guide.
Your system administrator must configure the system for correct video resolution.
When you are not in a call, you can set the refresh frequency of the monitor display:
•
Set to 50 Hz by pressing
•
Set to 60 Hz by pressing
The system displays a blank screen.
Verify the power cord of the XT Codec Unit is connected properly at both ends.
Verify the monitor's power cord is connected properly at both ends.
Check that the monitor power switch is set to ON.
Verify the XT Codec Unit's LED is on. If the LED is blinking, press the Power key
Remote Control Unit.
Viewing system network information
then 5.
then 6.
on the XT
Troubleshooting the Scopia XT Series | 68