Configuring Audio Connections - RADVision Scopia XT5000 Administrator's Manual

Configuring Audio Connections

Part of the initial configuration is ensuring the microphones and speakers are set up correctly, and that
there is no noticeable echo across connections in a call or conference. The settings are detailed in these
sections:
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
Table 20: Configuring PIP-PaP option
Field Name
Multi Image Sets PIP and PaP activation, depending on the number of video
Mode streams available.
• auto: PIP and PaP are enabled only when needed. This
• On: PIP and PaP are enabled if at least two video streams are
• Off: PIP and PaP are disabled.
When you are using two monitors, PIP can be forced only if there
are at least three different video streams.
Multi Image Type Sets the PIP and PaP functions.
• auto: Both PIP, PaP and PoP functions are enabled. Press
• PIP: Only PIP is enabled.
• PaP: Only PaP is enabled.
• PoP: Only PoP is enabled.
PIP - Position Sets the position of the small image on the monitor: upper left, upper
right, lower left, lower right.
PIP - Rotation Enables/disables image rotation and controls the direction in which
the image rotates. Press the Layout
rotation (if enabled).
• Fixed: The image does not change position.
• Clockwise: Image rotates clockwise to change position.
• Counterclockwise: Image rotates counterclockwise to
c. From the web interface only, select Save.
Description
occurs when the number of video streams is greater than the
number of available monitors. The order of the video streams
is set automatically, with precedence to the remote video
streams.
available. If there is one video stream, the image shows in full
screen (for example, when the system is not connected).
Important:
the Layout key to switch between PIP, PaP and PoP.
change position.
key to activate image
Initial Configuration | 73