RADVision Scopia XT5000 Administrator's Manual page 145

Solution
Possible Causes
Solution
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
Important:
If the GLAN2 port is enabled and in use, check that it is properly connected.
Assign a valid IP address to the system on GLAN1 or GLAN2, as described in
Addresses on page 81.
The system is capable of detecting IP/MAC addresses conflicts in a network. The conflict
occurs with static IP addresses if administrators have inadvertently attributed the same IP
addresses to devices or with dynamic IP addresses due to a DHCP server problem.
Verify that another the IP address defined for this endpoint is unique in the network. If there is
an address conflict, redefine the IP address.
If configuring from the endpoint, you must first enable advanced configuration, as described
in Maintaining the XT Endpoint Locally from the Endpoint
1. From the endpoint's main menu, select Configure > Quick Setup.
2. Press Next several times until the Configure TCP/IP screen appears.
3. Enter the IP address.
Figure 90: GLAN1 port
Figure 91: Configuring IP address
Troubleshooting the Scopia XT Endpoint for IP Office | 145
Configuring IP
on page 35.