Before You Begin - RADVision Scopia XT5000 Administrator's Manual

Before you begin

• If configuring from the endpoint, you must first enable advanced configuration, as described in
Maintaining the XT Endpoint Locally from the Endpoint
• By default, remote management is enabled. If you changed this configuration, make sure that you
enable it as described in
on page 25.
Procedure
1. Access the remote download settings, as follows:
2. Set the fields as described in
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
Enabling Remote Management on the Scopia XT Endpoint for IP Office
• From the endpoint's main menu, select Administrator Settings > Utilities > Remote
Access > Download.
• From the XT Endpoint web interface, select Configure > Advanced > Utilities >
Remote Access > Download.
Figure 9: Enabling remote access to the XT Endpoint
Table 9: Enabling remote upgrade
Field Name
Download Configure whether to allow remotely downloading firmware or
Management patches to the XT Codec Unit via a Windows PC upgrade
program, as follows:
Enable all addresses Allow access to the XT Codec Unit from all or specific PCs, as
follows:
on page 35.
Table 9: Enabling remote upgrade
Description
• Select Yes to enable remote downloads to the XT Endpoint.
• Select No to disable remote downloads to the XT Endpoint.
• Select Yes to enable access to XT Endpoint from any IP
address in a network.
• Select No to allow access to specified computers only. If
selected, you must also configure the Address and SubNet
mask as described below.
Getting Started with Managing the XT Endpoint | 28
on page 28.