Configuring Remote Upgrade Settings - RADVision Scopia XT5000 Administrator's Manual

3. From the web interface only, select Save.
4. To perform remote upgrades, enable remote downloads as described in

Configuring Remote Upgrade Settings

About this task
In order to upgrade your Scopia XT Endpoint for IP Office from the web interface, remote upgrade must
be enabled. This procedure describes how to:
• Enable/disable remote upgrades (it is enabled by default)
• Limit access to specific computers in the network. By default, all computers in the network can
perform remote upgrades.
You can do this procedure from the endpoint itself or from the XT Endpoint web interface.
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
Field Name
Enable all Allow access to remote management for all or specific PCs, as
addresses follows:
• Select Yes to enable access to XT Endpoint from any IP
• Select No to allow access to specified computers only. If
Address This field is only relevant if you set the Enable all addresses field to
No.
Enter the IP address or IP addresses of the computers allowed to
access XT Endpoint.
Subnet Mask This field is only relevant if you set the Enable all addresses field to
No.
Enter the Subnet mask associated with the IP address or group of IP
addresses specified above.
User Name The current credentials for remote access are displayed.
Password
Modify the credentials here. You must be connected via HTTPS (see
above).
The default username for the web interface is Admin and the default
password is 1234.
We strongly recommend that you change the default credentials the
first time you access the XT Endpoint remotely.
Upgrade SettingsConfiguring Remote Upgrade Settings
Description
address in a network.
selected, you must also configure the Address and SubNet
mask as described below.
Getting Started with Managing the XT Endpoint | 27
Configuring Remote
on page 0 .