RADVision Scopia XT5000 Administrator's Manual page 124

Configuring Remote Upgrade Settings
About this task
In order to upgrade your Scopia XT Endpoint for IP Office from the web interface, remote upgrade must
be enabled. This procedure describes how to:
• Enable/disable remote upgrades (it is enabled by default)
• Limit access to specific computers in the network. By default, all computers in the network can
perform remote upgrades.
You can do this procedure from the endpoint itself or from the XT Endpoint web interface.
Before you begin
• If configuring from the endpoint, you must first enable advanced configuration, as described in
Maintaining the XT Endpoint Locally from the Endpoint
• By default, remote management is enabled. If you changed this configuration, make sure that you
enable it as described in
on page 25.
Procedure
1. Access the remote download settings, as follows:
2. Set the fields as described in
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
Enabling Remote Management on the Scopia XT Endpoint for IP Office
• From the endpoint's main menu, select Administrator Settings > Utilities > Remote
Access > Download.
• From the XT Endpoint web interface, select Configure > Advanced > Utilities >
Remote Access > Download.
Figure 72: Enabling remote access to the XT Endpoint
Table 40: Enabling remote upgrade
on page 35.
on page 125.
Maintaining the Scopia XT Endpoint for IP Office | 124