RADVision Scopia XT5000 Administrator's Manual page 82

HTTP, SNMP, and AT commands management occurs in IPv4 only, even if you set the system to
support dual mode. You can configure the IPv4 address manually or automatically.
Media streams in the same conference can be a mixture of IPv4 and IPv6.
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Maintaining the XT Endpoint Locally from the Endpoint
Procedure
1. Access the general network settings, as follows:
2. Set the Use IPv6 field to enable or disable IPv6 support.
3. From the web interface only, select Save.
4. Access the IP address settings, as follows:
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
• From the XT Endpoint web interface, select Administrator Settings > Networks >
Preferences > General.
• From the endpoint's main menu, select Configure > Network.
Figure 40: Enabling IPv6 mode
• From the endpoint, select either GLAN 1 or GLAN 2.
• From the web interface, select Addresses under GLAN 1 or GLAN 2.
on page 35.
Initial Configuration | 82