Implementing Port Security For The Scopia Xt Endpoint For Ip Office; Ports To Open On The Xt Endpoint - RADVision Scopia XT5000 Administrator's Manual

Reference Guide for Scopia XT Endpoint for IP Office API, which includes the list of commands over the
Ethernet interface.
Implementing Port Security for the Scopia XT Endpoint for
IP Office
The Scopia XT Endpoint for IP Office provides video technology for room conferencing, including
support for dual stream 1080p video, high quality data sharing, high quality full band audio and a high-
capacity embedded MCU (selected models).
This section details the ports used for the Scopia XT Endpoint for IP Office and the relevant
configuration procedures:
Navigation
•

Ports to Open on the XT Endpoint

•
Configuring the TCP or UDP Port Range on the Scopia XT Endpoint for IP Office
Ports to Open on the XT Endpoint
The Scopia XT Endpoint for IP Office is typically located in the enterprise network and is connected to
the DMZ. When opening ports to and from the Scopia XT Endpoint for IP Office, use the following as a
reference:
• If you are opening ports that are both to and from the XT Endpoint, see
to Open on the XT Endpoint
• If you are opening outbound ports from the XT Endpoint, see
from the Scopia XT Endpoint for IP Office
Important:
The specific firewalls you need to open ports on depends on where your XT Endpoint and other
Scopia Solution products are deployed.
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
on page 17
on page 18.
on page 20.
Planning the Topology of the Scopia XT Endpoint for IP Office
on page 20
Table 6: Bidirectional Ports
Table 7: Outbound Ports to Open
Deployment | 17