Upgrading The Scopia Xt Endpoint For Ip Office Software Using A Usb Drive - RADVision Scopia XT5000 Administrator's Manual

Upgrading the Scopia XT Endpoint for IP Office Software Using a
USB Drive
About this task
Your Scopia XT Endpoint for IP Office comes with a USB drive containing the latest firmware version
available at the time the system was shipped. We recommend that you always access the Radvision site
to check if a later version is available.
Before you begin
Check if a later version is available by accessing the Radvision site as explained in
for Scopia XT Endpoint for IP Office
If a later version is available, download it and copy onto the USB drive.
Procedure
1. Turn on the Scopia XT Endpoint for IP Office.
2. Insert the USB drive into one of the USB ports on the back panel of the XT Codec Unit.
3. Follow the instructions displayed on the screen.
4. The upgrade procedure may automatically continue after the reboot, and therefore reboot
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
Important:
Do not turn off the Scopia XT Endpoint for IP Office before the upgrade procedure is
completed.
on page 123.
Wait for the menus to appear on the monitor.
Figure 75: The USB ports on the back panel of the Scopia XT Endpoint for IP Office
The upgrade procedure begins automatically.
Caution:
After download begins do not shut down the XT Codec Unit until download is completed.
The system restarts automatically after the upgrade procedure is completed.
again. Wait a few minutes to ensure that the upgrade procedure is completed.
Updating Software
Maintaining the Scopia XT Endpoint for IP Office | 127