RADVision Scopia XT5000 Administrator's Manual page 66

Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
Table 17: Configuring general camera settings
Field Name
Default camera
Driver
Camera control by far site Enables/disable control of my camera(s) by the remote
Bring back to place
Description
Select the port of the XT Codec Unit which you connected the
default camera, which is automatically activated when the
system powers up.
Figure 32: Video inputs of the XT Codec Unit
• HD1: Select if you connected the default camera to the
HDMI input of the XT Codec Unit.
This is the most common configuration.
If you connected multiple cameras using the Scopia XT
Camera Switch, select the HD port of the Scopia XT
Camera Switch to which you connected the default
camera, from HD1- HD4.
• USB: Select if you connected the default camera to the
USB input of the XT Codec Unit.
• DVI: Select if you connected the default camera to the
DVI input of the XT Codec Unit.
For more information about connecting your camera to the
XT Codec Unit, see Installation Guide for Scopia XT Endpoint
for IP Office.
Important:
When using the Scopia XT Camera Switch, do not connect
cameras to ports HD1 and USB on the XT Codec Unit, as
these are used to connect the Scopia XT Camera Switch
itself. For more information, see Installation Guide for
Scopia XT Endpoint for IP Office.
Select the camera driver for the connected camera.
Automatic allows automatic identification of the correct driver
at system start up. Automatic detection for HD camera is
available only if the camera is connected using a VISCA
Cross cable.
endpoint.
If enabled, the system stores camera positions when the
camera is switched off, and restores this position the next
time the camera is switched on.
Initial Configuration | 66