RADVision Scopia XT5000 Administrator's Manual page 95

6. From the web interface only, select Save.
7. Access the IP settings as follows:
8. Set the fields as described in
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
Field Name
Rate K (ISDN)
Local audio-video (MCU)
• From the web interface, select Administrator Settings > Calls > Preferences > IP.
• From the endpoint interface, select Configure > Advanced > Calls > Preferences >
IP.
Figure 49: Configuring the IP settings from the web interface
Table 32: Configuring the IP-related call settings
Field Name
DTMF RFC2833 (H.323)
RTP Firewall
Description
Sets the maximum call rate that the system uses for all
incoming or outgoing calls in ISDN connectivity.
If using the system as an endpoint that can also host
conferences on the embedded MCU, select Yes to include
local video and audio in videoconferences.
Select No to hide the local audio and video and use the
system as an MCU.
Table 32: Configuring the IP-related call settings
DTMF describes a method to send DTMF inside
an audio stream. This method is normally used in
SIP protocol but is uncommon in H.323.
If set to Yes, the H.323 application in the XT
Codec Unit can use DTMF transmission. Verify the
remote endpoint supports RFC2833 before
enabling this field.
If set to Yes, the XT Codec Unit checks the source
of the RTP packets (audio, video, and
presentation) it receives to verify that it matches
the remote endpoint's IP address.
on page 95.
Description
Initial Configuration | 95