RADVision Scopia XT5000 Administrator's Manual page 126

• Download the update as explained in
page 123, or contact Customer Support.
• Ensure that a computer in your network with Windows OS is available.
Procedure
1. Verify the XT Codec Unit is switched on, and is connected to the IP network interface.
2. Verify that the network allows communication between the Codec Unit and the computer,
3. Download the .exe file (for example, XT5000_Vxxx.exe) from the Radvision site to the
4. On the computer, launch the .exe upgrade file. It automatically starts the upgrade program.
5. Enter the IP address of the XT Codec Unit in the start screen and select Start.
6. The upgrade procedure may automatically continue after the reboot, and therefore reboot
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
The network cable must be connected to the rightmost GLAN connector, GLAN1, on the
back panel of the XT Codec Unit.
and that a firewall does not block TCP port 55099.
computer.
Important:
The XT5000_Vxxx.exe upgrade package can be used to upgrade any Scopia XT
Executive, XT4000, or XT Endpoint.
Figure 74: Upgrading the firmware of the Scopia XT Endpoint for IP Office
The software is downloaded to the XT Codec Unit. You can view the progress on the Scopia
XT Endpoint for IP Office.
Caution:
After download begins do not shut down the XT Codec Unit until download is completed.
At the end of the update, the XT Codec Unit reboots automatically.
again. Wait a few minutes to ensure that the upgrade procedure is completed.
Updating Software for Scopia XT Endpoint for IP Office
Figure 73: GLAN1 port
Maintaining the Scopia XT Endpoint for IP Office | 126
on