Registering The Xt Endpoint To Ip Office - RADVision Scopia XT5000 Administrator's Manual

Registering the XT Endpoint to IP Office

About this task
The procedure in this section explains how to register your XT Endpoint to the IP Office SIP Registrar
and how to configure the SIP Proxy connection. If you do not register to IP Office, you cannot host
videoconferences or use the full functionality of the system.
The XT Endpoint can be configured to function in a SIP environment, where aliases are managed by SIP
servers rather than gatekeepers. In a SIP environment, a user can contact an endpoint by entering its
alias, rather than having to remember the endpoint's IP address. For example, you can dial "1234" or
"joesmith" and the SIP server routes the call correctly. To do this, the SIP server must register all
endpoints to maintain the mapping list of aliases and endpoints to successfully route calls.
Before you begin
Verify that you have the following information about your SIP environment:
• The DNS names or IP addresses of the Avaya IP Office server.
• The transport port used in your SIP environment.
• Credentials for authenticating XT Endpoint to the Avaya IP Office server.
If configuring from the endpoint, you must first enable advanced configuration, as described in
Maintaining the XT Endpoint Locally from the Endpoint
Procedure
1. Access the SIP settings as follows:
Administrator Guide for Scopia XT5000 Endpoint with Embedded
Server for IP Office Version 3.2
• From the XT Endpoint web interface, select Administrator Settings > Protocols >
SIP.
• From the endpoint's main menu, select Configure > Advanced > Protocols > SIP.
on page 35.
Initial Configuration | 62