Resolving Monitor Display Problems - RADVision Scopia XT Executive User Manual

Resolving Monitor Display Problems

Problem
Solution
Problem
Solution
Solution
Solution
Solution
Solution
RADVISION | User Guide for Scopia XT Executive Version 3.1.1
Figure 6-2
The system displays blank screen.
Your system administrator must configure the system for correct video resolution.
When you are not in a call, you can set the refresh frequency of the monitor display:
•
Set to 50 Hz by pressing
•
Set to 60 Hz by pressing
The system displays a blank screen.
Verify the power cord of the XT Codec Unit is connected properly at both ends.
Verify the monitor's power cord is connected properly at both ends.
Check that the monitor power switch is set to ON.
Verify the XT Codec Unit's LED is on. If the LED is blinking, press the Power key
Remote Control Unit.
Make sure the XT Codec Unit output is properly connected to the monitor input. Make sure
the monitor/DVI cable is connected properly at both ends.
Viewing system network information
then 5.
then 6.
on the XT
Troubleshooting the Scopia XT Series | 83