Drive Shaft - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

26-10

DRIVE SHAFT

REMOVAL AND INSTALLATION
Caution
1. If the vehicle is equipped with the Brembo disc brake, during maintenance, take care not to
contact the parts or tools to the caliper because the paint of caliper will be scratched. And
if there is brake fluid on the caliper, wipe out quickly.
2. For vehicles with ABS or ACD, do not strike the rotor for wheel speed sensor installed to
the B.J. outer race of drive shaft against other parts when removing or installing the drive
shaft. Otherwise the rotor for wheel speed sensor will be damaged.
Pre-removal and Post-installation Operation
Transmission Fluid Draining
D
Transfer Oil Draining (Refer to GROUP 22 –
D
On-vehicle Service.)
11
10
11
39 5 N m
Removal steps
1. Split pin
"BA 2. Castle nut
3. Front speed sensor <Vehicles with
ABS or ACD>
4. Front speed sensor harness brack-
et
5. Brake hose bracket
FRONT AXLE -
4
5
9
6
7
108 10 N m
Drive Shaft
Pre-removal and Post-installation Operation
Check the Dust Cover for cracks or damage by
D
pushing it with finger.
Transfer Oil Filling (Refer to GROUP 22 –
D
On-vehicle Service.)
Transmission Fluid Filling
D
25
25
2
245
8
6. Stabilizer bar link connection
7. Lower arm ball joint connection
8. Tie rod end connection
AA"
AB" "AA 9. Drive shaft
AC" "AA 10. Output shaft
11. Circlip
5 N m
4 N m
3
1
29 N m