Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 590

<Driver's side>
<RS>
<RS-II>
Connector
Steering
wheel - driver's
air bag module
assembly
<Front passenger's side>
Inflator case
Case
Protective tubes
2
SRS - Air Bag Modules and Clock Spring
INSPECTION
Inflator
DRIVER'S AND PASSENGER'S AIR BAG MODULE
INSPECTION
If any malfunction is found in the following inspection, replace
the air bag module(s) with new one(s).
Discard the old one(s) after deployment as specified in the
service procedure. (Refer to P.52B-64.)
Caution
Never measure circuit resistance in the air bag modules
Connector
(squib) even with the specified tester. Measuring the
circuit resistance with a tester causes accidental air bag
deployment due to current that flows or static, resulting in
serious personal injury.
1. Check the cover for dents, cracks or deformation.
2. Check the connectors for damage, terminals for
3. Check the air bag inflator cases for dents, cracks or
4. With air bag module installed
Connector
CLOCK SPRING CHECK
If any malfunction is found in the following inspections, replace
the clock spring with a new one.
1 <RS>
1. Check the connectors and protective tubes for damage,
2. Visually check the case for damage.
3. Refer to that the clock spring has continuity between
deformation, and harness for binds.
deformation.
Caution
If dents, cracks, deformation, or rust are present in
the air bag module(s), replace with new one(s).
Discard the old one(s) as specified in the service
procedure. (Refer to P.52B-64.)
and terminals for deformation.
connector No.2 and terminal No.4 of connector No.1.
52B-59