Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 646

BODY -
MB990480
Window Glass
3. Make alignment marks on the windshield and body.
4. Use the special tool to remove the windshield.
5. Use a knife to cut away remaining adhesive to 2 mm
thick or less around the entire circumference of the body
flange.
6. Smooth the flange surface.
Caution
(1) Use care not to remove more adhesive than
necessary, or the adhesive could weaken.
(2) Be careful also not to damage the paintwork on
the body surface with the knife. If the paintwork
is damaged, repair the damaged area with repair
paint or anti-rust agent.
7. When reusing windshield, remove the remaining adhesive
on the windshield completely. Then, decrease the
windshield with isopropyl alcohol.
8. Decrease the body flange in the same way.
Caution
Before the next job, leave the decreased parts for
3 minutes or more to dry. Also, do not touch any
cleaned surface.
42-13