Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 412

HEATER, AIR CONDITIONER AND VENTILATION
Dashboard pad
Blower unit
25
20
15
Resistance
(kΩ)
10
5
0 - 10
0 10 20
Temperature(_C)
AB" EVAPORATOR REMOVAL
1. When removing the evaporator, cut and fold back the
dashboard pad as in the diagram. (The thickness of the
pad interferes with the removal of the evaporator.)
2. Remove the evaporator.
Caution:
Do not cut the upper side of the pad.
INSTALLATION SERVICE POINTS
"AA EVAPORATOR INSTALLATION
After installing the evaporator, glue the cut dashboard panel
pad with an adhesive agent.
INSPECTION
Air thermo sensor inspection
Measure the resistance between connector terminals 4 and
5 under at least two different temperatures. The resistance
values should generally match those in the graph.
NOTE
The temperature at the check should not exceed the range
in the graph.
40
30
-
Evaporator, Air Thermo Sensor
<R.H. DRIVE VHEICLESE>
55-35