Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1339

11A-38
Engine Front
Crankshaft
sprocket
Washer
Crankshaft bolt
Crankshaft sensing
blade
B
A
Wire
Tensioner pulley hole
ENGINE -
Timing Belt and Timing Belt B
"CA CRANKSHAFT SENSING BLADE/CRANKSHAFT
1. Clean and degrease the crankshaft sensing blade and
Crankshaft
2. Install the crankshaft sensing blade and crankshaft
3. Clean the tapped hole of the crankshaft.
4. Position the chamfered side of the washer to the direction
Clean
5. Apply a small quantity of engine oil to the contact surface
6. Use the special tool to hold the crankshaft sprocket and
Degrease
"DA AUTO-TENSIONER INSTALLATION
1. If the auto-tensioner rod is being extended, set according
2. Install the auto-tensioner to the engine and tighten the
"EA TENSIONER PULLEY INSTALLATION
Secure the tensioner pulley temporarily as shown in the
illustration.
SPROCKET INSTALLATION
the crankshaft sprocket mounting surfaces of the
crankshaft sprocket and the crankshaft.
sprocket to the direction as shown in the illustration.
as shown in the illustration and install to the crankshaft
bolt.
and the threads of crankshaft bolts.
tighten the the crankshaft bolt to the specified torque
in the same way as that for removal.
Tightening Torque: 162 ± 5 N·m
to the following procedure.
(1) Use a press or a vise to compress the rod of the
auto-tensioner slowly and align the mounting hole
A of the rod with the mounting hole B of the tensioner
cylinder.
Caution
Ensure that the operation should be done slowly
because quick compression could damage a rod.
(2) Insert a wire or etc. into the mated mounting hole.
NOTE
If the automatic tensioner is replaced with a new one,
the automatic tensioner comes with a new pin.
mounting bolt to the specified torque. Do not remove
a wire or a pin before completing timing belt tension
adjustment.
Tightening Torque: 23 ± 3 N·m