Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1196

Table of Contents

Advertisement

Inspection Procedure 6
Starting disabled (Starter rotates but initial combustion
does not occur.)
Causes shown on right are suspected.
Check the battery. (Refer to GROUP 54 - Battery.)
OK
Check the engine warning lamp.
D Ignition switch: ON
OK: Engine warning lamp is illuminated.
OK
MUT-II Self-Diag code
D Is a diagnosis code output?
NO
MUT-II Actuator test
D No. 7: Fuel pump relay
OK: Fuel pump operation sound is heard.
YES
Does the camshaft rotate during engine cranking?
YES
MUT-II Data list
D No. 18: Cranking signal
D Ignition switch: ST
OK: ON
D Ignition switch: ON
OK: OFF
OK
MUT-II Data list
D No. 22: Crank angle sensor (Refer to P.13A-103.)
OK
Check the following connectors:
B-114, B-119
OK
Measure at the B-114 and B-119
ignition coil connectors.
D Disconnect the connector to
measure at the harness side.
D Ignition switch: ON
D Voltage between terminal No. 1 and
earth
OK: System voltage
OK
To the next page
MPI -
Troubleshooting
NG
NG
YES
NO
NO
NG
NG
NG
Repair
NG
Check the following connectors:
B-123, B-119
Check and repair the harness between
the ignition switch and ignition coil for
each cylinder.
D Check for disconnection and
short-circuit of the power cable.
Probable cause
D Battery malfunction
D Ignition switch malfunction
D Ignition system malfunction
D Fuel system malfunction
D Throttle valve malfunction
D Timing belt malfunction
D Engine-ECU malfunction-
Replace the battery.
Check the Inspection Procedure 22: Engine-ECU power supply,
engine control relay, ignition switch-IG1 system.
(Refer to P.13A-82.)
INSPECTION CHART FOR DIAGNOSIS CODE
(Refer to P.13A-12.)
Check the Inspection Procedure 23: Fuel pump system.
(Refer to P.13A-85.)
Check the timing belt for defects.
Check the following
connector: C-42
OK
Check and repair the harness between the ignition switch inter-
mediate connector and engine-ECU.
D Check for disconnection of the output cable.
Check the Code No. P0335: Crank angle sensor system.
(Refer to P.13A-35.)
NG
OK
13A-59
NG
Repair
Repair

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents